Titanium Tips are tested tough
Goodtool Titanium Coated Cutting Tips will increase your profit margin. Here's how.
- Titanium coated tips last longer than uncoated tips
- Titanium coated tips deliver a better finish in a single pass so you work faster and get more cuts per tip
The titanium coating is applied to a carbide substrate. This coating is specifically developed for cutting, turning and boring most materials at moderate to low speeds. Its unique mechanical and thermal shock resistant properties make it ideal for cutting today's drums and rotors while providing longer life for more cuts per tip.
Make your shop more profitable
For even better performance, try our Round Titanium Cutting Tips. A single pass with the round tip yields a much better finish than a single pass with a triangular tip. With standard triangular tips, it takes an average of 15 minutes to resurface two rotors. With our Titanium coated round tips you can aggressively cut four rotors in the same amount of time. You get more done in less time, increasing your billable time.
Goodtool's most popular cutting tips were recently run through a battery of tests and the results speak for themselves ...
Titanium Tips outperform all others!
Standard vs. Honed Edge vs. Titanium Coated vs. Round Cutting Tips
Conditions |
Results |
|
 Standard
Triangle
|
Honed Edge
Triangle
|
Titanium
Triangle
|
Standard Round
|
Titanium Round
|
Single Pass Cut: .006" off of each side
Rotor Diameter: 11"
Machine Speed: Full |
135RA |
121RA |
109RA |
73RA |
77RA |
Single Pass Cut: .010" off of each side
Rotor Diameter: 11"
Machine Speed: Medium |
123RA |
131RA |
97RA |
74RA |
65RA |
Fast Cut: .006" off of each side
Slow Cut: .002" off of each side
Rotor Diameter: 11" |
50RA |
50RA |
49RA |
35RA |
33RA |
Note: An RA finish of 14-70 off the production line is recommended. The lower the RA number, the better the finish. |
Triangular Cutting Tips vs. Round Cutting Tips
| |
Standard |
| |
Triangle RT-A |
Round RT-312 |
| |
Temp |
RA |
Temp |
RA |
| Test A |
136 |
133 |
110 |
73 |
| Test B |
138 |
136 |
109 |
74 |
| Test C |
138 |
138 |
110 |
76 |
| Test D |
136 |
140 |
109 |
77 |
| Test E |
139 |
143 |
109 |
78 |
| |
Titanium |
| |
Triangle RT-A-T |
Round RT-312-T |
| |
Temp |
RA |
Temp |
RA |
| Test A |
103 |
101 |
94 |
77 |
| Test B |
103 |
101 |
94 |
65 |
| Test C |
121 |
101 |
96 |
68 |
| Test D |
128 |
127 |
104 |
71 |
| Test E |
36 |
132 |
110 |
74 |
Test Conditions:
Single Pass Cut: .006" off each side
Rotor Diameter: 11"
Machine Speed: Fast
Each Test is another pass with the same cutting tip. For example, Test D represents four (4) passes with the same tip.
|
